N2XS(F)2Y

General information

Standard: TŞ AZ 2002283071.008 (IEC 60840) The Russian analogue : PvPu They are used for stationary laying in the ground and trenches, regardless of the degree of corrosiveness of soil and water. Cables of this trademark can be used in cable lines (under the condition of using a shell that meets the fire safety requirements). Cables can be installed without restrictions for the level difference. It is allowed to install cables of this trademark on complicated cable routes.

XLPE insulated high voltage cable with a copper conductor, a water-blocking semi-conductive tape and a sheath of polyethylene (PE)

Structure:

  1. The conductor is copper, multi-wire, round and compacted; corresponds to class 2 of IEC 60228
  • The cross-section of a multi-wire compacted round conductor is 185÷800 mm2
  • The cross-section of a multi-wire compacted round conductor, consisting of 5 sectors, is 1000÷1600 mm2
  1. The conductor screen is made of extruded semiconducting cross-linked polyethylene
    3. Insulation is cross-linked polyethylene (2X)
    4. Insulation screen is made of extruded semiconducting cross-linked polyethylene
    5. The separation layer is made of semi-conductive water-blocking tape
    6. The screen is of copper wires fastened with copper tape (S)

Minimum cross-section of screen for cables with a conductor cross-section of 185-800 mm2 - 35 mm2
Minimum cross-section of screen for cables with a conductor cross-section of 1000 mm2 and above is 50 mm2

The maximum cross-section of screen can be set based on the customer's require.

  1. The separation layer is made of PETF tape
    8. The outer protective sheath is made of packed polyethylene (2Yy)

Specifications:

  • Operating temperature of the conductor: +90 0C
  • The maximum heating temperature of the cable conductors in case of emergency: +130 0C
  • The maximum heating temperature of the cable conductors in case of emergency: +250 0С
  • The duration of a short circuit (not more than): 5 seconds
  • Cable laying temperature (not less than): -15 0С
  • Ambient temperature: -60 / +50 0C
  • Minimum bending radius of the cable: 15xD (D is outer diameter of the cable)

NOTE: Technical specifications are given in Table 1